- Make sure that the power cord is connected to the power outlet and connected securely to the E800's Power Supply Unit (PSU), and that it is switched on.
- Push the power on switch on the front of the E800.
- Should the problem persist, then this may be an issue with the motherboard or the chassis switch cable connections:
- Reset the CMOS BIOS :
- Unplug the power cord from the PSU.
- Remove the chassis top cover:
- Short the CMOS pin – refer to the motherboard manuals.
- Remove the CMOS battery, wait at least 10 seconds and reinstall the CMOS battery.
- Plug the power cord and power on the unit.
- Reset the CMOS BIOS :
- If this does not resolve the issue:
- Check the circuit board that connects to the front panel swicthes (on/off and reset):
- Check the circuit board underneath the SSD cage – remove this cage to access the board.
- Make sure that all cables are secured. Cable connections from the motherboard to this board may came loose during shipping.
- Check the circuit board that connects to the front panel swicthes (on/off and reset):
- If the issue still persist, the problem may be with the motherboard itself:Contact the Blancco Technical Support teamVergewissern Sie sich, dass das Netzkabel an eine Steckdose angeschlossen ist, korrekt an das Netzteil der E800 gesteckt ist und dass es eingeschaltet ist.
- Drücken Sie den Netzschalter an der Vorderseite der E800.
- Wenn das Problem weiterhin besteht, kann dies ein Problem mit den Kabelverbindungen des Motherboards oder des Gehäuses sein:
- Setzen Sie das CMOS-BIOS zurück:
- Ziehen Sie das Netzkabel vom Netzteil ab.
- Entfernen Sie die obere Gehäuseabdeckung:
- Verbinden Sie die CMOS-Pins - siehe Handbücher der Hauptplatine.
- Entfernen Sie die CMOS-Batterie, warten Sie mindestens 10 Sekunden und setzen Sie die CMOS-Batterie wieder ein.
- Verbinden Sie die CMOS-Pins - siehe Handbücher der Hauptplatine.
- Stecken Sie das Netzkabel ein und schalten Sie das Gerät ein.
- Setzen Sie das CMOS-BIOS zurück:
- Wenn das Problem dadurch nicht behoben wird:
- Überprüfen Sie die Platine die mit den Frontblenden verbunden ist (Ein / Aus und Reset):
- Überprüfen Sie die Platine unter dem SSD-Halter - entfernen Sie diesen Halter um auf die Platine zuzugreifen.
- Überprüfen Sie die Platine unter dem SSD-Halter - entfernen Sie diesen Halter um auf die Platine zuzugreifen.
- Stellen Sie sicher, dass alle Kabel gesichert sind. Kabelverbindungen von der Hauptplatine zu dieser Platine können sich während des Versands lösen.
- Überprüfen Sie die Platine die mit den Frontblenden verbunden ist (Ein / Aus und Reset):
- Wenn das Problem weiterhin besteht, liegt das Problem möglicherweise am Motherboard selbst:
- Wenden Sie sich an den technischen Support von Blancco.
Content Comparison
General
Content
Integrations